EXFO MaxTester 630G User Manual page 83

Application Settings
Before executing the DSL/IP tests, the Application Settings function allows
you to set general settings and identification fields.
To access Application Settings:
From the Home pane, select DSL/IP Tests, Setup, and then
Application Settings. The following parameters are available to
configure:
General
The General tab allows you to configure the unit with
specific measurement values.
Report File Storage Location is dependent on

whether Export to EXFO Connect Client is
enabled or not, in System Settings\Upload Setup.
If enabled, you can select either USB or EXFO
Connect Client as your test report storage
location. If disabled, USB is automatically
selected.
Report Format is MaxTester, HTML, MHTML, or

XML as the generated report format.
Note: If EXFO Connect Client is selected, the available selections for Report
Format are only MHTML and XML.
Result File Storage Location allows you to select where to save your

results: to a USB or the internal memory of the MaxTester.
Prompt To Save Results allows you to Enable/Disable popup

confirmation messages before leaving a test and not saving results.
Show Time Beep allows you to select the time span for a beep from 0

to 3 seconds.
G.fast/VDSL2/ADSL2+ Multi-play Test Set
Setting Up DSL/IP Tests
Setup
77