EXFO MaxTester 630G User Manual page 54

Setting Up DSL/IP Tests
Test Configuration
Annex M allows you to Enable/Disable this option when Test

Interface is:



Annex J allows you to Enable/Disable this option when Test Interface

is:


ADSL Transport displays the transport type options: PTM (packet

transfer mode), ATM (asynchronous transfer mode), or ATM and PTM.
When G.fast is selected as the Test Interface, ADSL Transport is
disabled.
Access Mode options are dependent on the test setup selection.



Note: IPv6 requires an option key to be enabled.
Auto Resync allows you to Enable the SyncLossCounter as the

Pass/Fail criteria. When SyncLossCounter+1 is reached, the test will
have fail status.
If Auto Resync is disabled, any time the test loses sync, the result status
will be fail and the test will stop automatically.
48
VDSL2/ADSL2+ or VDSL2/ADSL2+ Bonding for V2XAA and GVXAA
units.
VDSL2/ADSL2+ (xA/P2) for V2XAB unit.
VDSL2/ADSL2+ (xA/Pair 1) for GVXAB unit.
VDSL2/ADSL2+ (xB/P1) for V2XAB unit.
ADSL2+ (xB/Pair 2) for GVXAB unit.
For Auto and Manual tests, available options are: Sync Only,
Bridged (not in Auto Test), DHCP , Static, PPPoE, PPPoA, IPoA, and
IPv6 (DHCP).
For Ethernet tests, available options are Bridged, DHCP, Static,
PPPoE, and IPv6 (DHCP).
MAX-630G