Full Spectrum Laser MUSE 3D Operation Manual page 86

Section VII. Operations
Camera Calibration
5. Close the lid: Close the lid of the machine.
6. Verify no jobs: Ensure that there are no jobs actively on your machine or remove the water supply from
the machine so that the machine will not cut the calibration sheet. If the calibration sheet is damaged, the
recalibration process may not be effective.
7. Enter tools tab: Touch the Tools tab on the LCD screen of your machine.
8. Select Camera Calibration: Touch the Camera Calibration button under the tools tab and select Stitch
Calibration. This process should take about 5 minutes.
Enter tools tab: Touch the Tools tab on the LCD screen of your machine.
elect Camera Calibration: Touch the Camera Calibration button under the tools tab and select
itch Calibration. *NOTE* the camera will take multiple images of the calibration sheet and use
e data to calibrate the camera to the work space. Avoid opening the lid during the calibration
ocess. This process should take about 5 minutes.
NOTICE
Select Camera Calibration: Touch the Camera Calibration button under the tools tab and
8.
Stitch Calibration. *NOTE* the camera will take multiple images of the calibration sheet and
the data to calibrate the camera to the work space. Avoid opening the lid during the calibra
process. This process should take about 5 minutes.
6
7
8
8. Select Camera Calibration: Touch the Camera Calibration button under the tools tab a
select Stitch Calibration. *NOTE* the camera will take multiple images of the calibration shee
use the data to calibrate the camera to the work space. Avoid opening the lid during the calib
process. This process should take about 5 minutes.
The camera will take multiple images of the calibration sheet and use the data to calibrate
the camera to the work space. Avoid opening the lid during the calibration process.
Technical Support is available 8am-5pm PST. Monday - Friday
support@fslaser.com • 702-802-3103
85