Full Spectrum Laser MUSE 3D Operation Manual page 32

Section IV. Tests & Adjustments
2. Mirror Alignment Procedure
Stage 4: Align Mirror #2 to Mirror #3
Stage 4: Align Mirror #2 To Mirror #3
The 3rd mirror is mounted on the laser head assembly and slides along the X-gantry rail.
The 3rd mirror is mounted on the laser head assembly and slides along the X-gantry
rail.
1. Open Safety Lid: You will need to access the interior of the machine.
1. Open Safety Lid:
2. Place Thermal Paper: Take a small piece of thermal paper (approx. 15 mm should be plenty) and place
2. Place Thermal Paper:
it firmly over Mirror #3.
and place it firmly over Mirror #3.
3. Position the Gantry Bar: Place the gantry bar in the center of the work bed, as shown in the diagram below.
3. Position the Gantry Bar:
diagram below.
4. Position Laser Head "Far": Jog or manually position the laser head to the far right (as shown in diagram).
4. Position Laser Head "Far":
This is the farthest position of the Mirror #3 from Mirror #2.
in diagram). This is the farthest position of the Mirror #3 from Mirror #2.
Figure 4.10
5. Close Safety Lid:
5. Close Safety Lid: Safety measures should make it impossible to fire the laser with the safety lid open. open. Regardless, never attempt to fire the laser with safety lid open.
Regardless, never attempt to fire the laser with safety lid open.
6. Test Fire the Laser:
fire the laser twice to see the burn mark on the thermal paper.
6. Test Fire the Laser: Press the Fire Laser Icon button on the touch screen. You may need to fire the laser
twice to see the burn mark on the thermal paper.
Technical Support is available from 8am to 5pm (PST) M - F at support@fslaser.com.
You will need to access the interior of the machine.
Take a small piece of thermal paper (approx. 15 mm should be plenty)
Place the gantry bar in the center of the work bed, as shown in the
Jog or manually position the laser head to the far right (as shown
Safety measures should make it impossible to fire the laser with the safety lid
Press the Fire Laser Icon button on the touch screen. You may need to
Technical Support is available 8am-5pm PST. Monday - Friday
support@fslaser.com • 702-802-3103
35
31