Full Spectrum Laser MUSE 3D Operation Manual page 22

Section III. Installation & Assembly
5. Connect Electical Power
Assembly Stage 2: Connect Electrical Power
Assembly Stage 5: Connect Electrical Power
Muse's Laser System, and available accessories, are configured to accept 110VAC at 60Hz.
Muse's Laser System, and available accessories, are configured to accept 110VAC at 60Hz. 220VAC units
220VAC
connect to power through an included converter (single-phase 220VAC).
units connect to power through an included converter (single-phase 220VAC).
1. Prepare Power Cord:
1.Prepare Power Cord: Remove the electrical cord from its packaging.
2. Plug in Power Cord To Laser Cutter:
2.Plug in Power Cord To Laser Cutter: The power cord plugs into a "C14" power receptacle located on the
right side of the machine.
located on the right side of the machine.
3.Plug in Power Cord to Outlet: Plug the power cord into any proper outlet socket in your workspace.
3. Plug in Power Cord to Outlet:
in your workspace.
Figure 3.16
NOTICE
Technical Support is available from 8am to 5pm (PST) M - F at support@fslaser.com.
Remove the electrical cord from its packaging.
Plug the power cord into any proper outlet socket
• Please be aware that the accessories will increase the circuit load.
PRO TIP!
The most significant power draw usually comes from the blower/ exhaust system. Please be aware that the accessories will increase the circuit
load; the most significant power draw usually comes from the blower/
Consult the manufacturer's information and manual for the operating parameters of
exhaust system. Consult the manufacturer's information and manual for
your exhaust system.
the operating parameters of your exhaust system.
• In case of blown fuse, the laser system is equipped with a fuse on the power
inlet to protect the machine from surges or short circuits. If this fuse ever
IN CASE OF A BLOWN FUSE:
needs replacement, please contact Full Spectrum Laser technical support.
a fuse on the power inlet to protect the machine from surges or short
circuits. If this fuse ever needs replacement, please contact Full
Spectrum Laser technical support.
Technical Support is available 8am-5pm PST. Monday - Friday
support@fslaser.com
The power cord plugs into a "C14" power receptacle
The laser system is equipped with
• 702-802-3103
21
24