Full Spectrum Laser MUSE 3D Operation Manual page 29

Section IV. Tests & Adjustments
2. Mirror Alignment Procedure
Stage 2: Align Laser Output to Mirror #1
Stage 2: Align Laser Output To Mirror #1
Stage 2: Align Laser Output To Mirror #1
Align the invisible cutting beam with the visible red beam diode and make sure they hit each mirror precisely.
Conceptually, you will be aligning the invisible cutting beam with the visible red beam diode and
Conceptually, you will be aligning the invisible cutting beam with the visible red beam diode and
Remember to check your mirror alignment before starting this procedure; it is probably unnecessary if the laser
making sure they hit each mirror precisely. Once again, remember to check your mirror alignment
making sure they hit each mirror precisely. Once again, remember to check your mirror alignment
tube was pre-installed in your Muse 3D.
BEFORE starting this procedure as it is likely unnecessary if the laser tube was pre-installed in your
BEFORE starting this procedure as it is likely unnecessary if the laser tube was pre-installed in your
Muse 3D.
Muse 3D.
Figure 4.6
Figure 4.6
1. Open the Safety Lid:
1. Open the Safety Lid: You will need to access the interior of the machine.
1. Open the Safety Lid:
2. Place Thermal Paper:
2. Place Thermal Paper: Take a small piece of thermal paper (approx. 15 mm should be plenty)and place it
2. Place Thermal Paper:
and place it firmly over Mirror #1.
firmly over Mirror #1.
and place it firmly over Mirror #1.
3. Close Safety Lid: Safety measures should make it impossible to fire the laser with the safety lid open. 3. Close Safety Lid:
Regardless, never attempt to fire the laser with safety lid open.
3. Close Safety Lid:
lid open. Regardless, never attempt to fire the laser with safety lid open.
lid open. Regardless, never attempt to fire the laser with safety lid open.
4. Test Fire the Laser: Press the Fire Laser Icon Button on the touch screen. You will see a burnmark on the
4. Test Fire the Laser:
thermal paper. It should hit the mirror in the middle.
mark on the thermal paper. It should hit the mirror in the middle.
4. Test Fire the Laser:
5. Adjust Red Beam: Using your 2.5m hex wrench, make micro adjustments to the threeadjustment screws of
mark on the thermal paper. It should hit the mirror in the middle.
5. Adjust Red Beam:
the red beam diode, and position the red dot exactly over the burn mark.
adjustment screws of the red beam diode, and position the red dot exactly over the burn mark.
5. Adjust Red Beam:
adjustment screws of the red beam diode, and position the red dot exactly over the burn mark.
Figure 4.7
Figure 4.7
Technical Support is available from 8am to 5pm (PST) M - F at support@fslaser.com.
You will need to access the interior of the machine.
You will need to access the interior of the machine.
Take a small piece of thermal paper (approx. 15 mm should be plenty)
Take a small piece of thermal paper (approx. 15 mm should be plenty)
Safety measures should make it impossible to fire the laser with the safety
Safety measures should make it impossible to fire the laser with the safety
Press the Fire Laser Icon Button on the touch screen. You will see a burn
Press the Fire Laser Icon Button on the touch screen. You will see a burn
Using your 2.5m hex wrench, make micro adjustments to the three
Using your 2.5m hex wrench, make micro adjustments to the three
Technical Support is available 8am-5pm PST. Monday - Friday
support@fslaser.com • 702-802-3103
28
32