Full Spectrum Laser MUSE 3D Operation Manual page 17

2. Attach Water Pump Fitting:
2. Attach Water Pump Fitting: Remove the water pump from its packaging. Attach the plastic fitting to
the water pump by gently screwing it on.
plastic fitting to the water pump by gently screwing it on. 2. Attach Water Pump Fitting:
plastic fitting to the water pump by gently screwing it on.
Figure 3.7
Figure 3.7
3. Prep Water Bucket:
3. Prep Water Bucket: Fill a clean 5-gallon bucket (not included) with 3 - 4 gallons of distilled water
3. Prep Water Bucket:
(not included). Only use distilled water and replace often. It is recommended that you choose a bucket water (not included). ALWAYS use only distilled water and replace often. It is recommended that you
water (not included). ALWAYS use only distilled water and replace often. It is recommended that you
choose a bucket with a lid and cut holes to allow the tubes to fit. This will prevent debris falling into
with a lid and cut holes to allow the tubes to fit. This will prevent debris falling into your water bucket.
choose a bucket with a lid and cut holes to allow the tubes to fit. This will prevent debris falling into
your water bucket.
your water bucket.
Figure 3.8
Figure 3.8
Technical Support is available from 8am to 5pm (PST) M - F at support@fslaser.com.
Technical Support is available from 8am to 5pm (PST) M - F at support@fslaser.com.
Remove the water pump from its packaging. Attach the
Remove the water pump from its packaging. Attach the
Fill a clean 5-gallon bucket (not included) with 3 - 4 gallons of distilled
Fill a clean 5-gallon bucket (not included) with 3 - 4 gallons of distilled
Technical Support is available 8am-5pm PST. Monday - Friday
support@fslaser.com • 702-802-3103
19
16
19