Full Spectrum Laser MUSE 3D Operation Manual page 21

3. Attach Air Hose to Laser Cutter:
inlet" nozzle in the back of laser cutter via the barbed air connect fitting.
3. Attach Air Hose to Laser Cutter:
3. Attach Air Hose to Laser Cutter: Insert the other end of the black air inlet hose into the "air inlet"
nozzle in the back of laser cutter via the barbed air connect fitting.
inlet" nozzle in the back of laser cutter via the barbed air connect fitting.
Figure 3.14
Figure 3.14
4. Connect to Power:
4. Connect to Power: Plug the air compressor into the upper power plug marked "air compressor" on the
4. Connect to Power:
back of your Muse 3D. Note that air compressor will only turn on when the laser is firing.
"air compressor" on the back of your Muse 3D. Note that air compressor will only turn on when
"air compressor" on the back of your Muse 3D. Note that air compressor will only turn on when
the laser is firing.
the laser is firing.
Figure 3.15
Figure 3.15
Technical Support is available from 8am to 5pm (PST) M - F at support@fslaser.com.
Technical Support is available from 8am to 5pm (PST) M - F at support@fslaser.com.
Insert the other end of the black air inlet hose into the "air
Insert the other end of the black air inlet hose into the "air
Plug the air compressor into the upper power plug marked
Plug the air compressor into the upper power plug marked
Technical Support is available 8am-5pm PST. Monday - Friday
support@fslaser.com • 702-802-3103
20
23
23