Full Spectrum Laser MUSE 3D Operation Manual page 48

RetinaEngrave v3.0 Software
Editor
Settings (B)
Save: Save project.
Undo: Reverse your last action.
Redo: Reverse your last undo.
Muse Control (q)
Capture Workspace: Takes images of workspace
Clear Last Workspace Capture: Clears previous workspace image.
Estimate Job Time: Amount of time the job will take.
Preview Contour of All Objects: Shows laser tracing of job.
Show Bounding Perimeter of all Objects: Shows the space the job will occupy.
Run Job: Start Engraving
Network
Technical Support is available 8am-5pm PST. Monday - Friday
support@fslaser.com
SECTION VI. SOFTWARE
Using RetinaEngrave v3.0 Software
In this section you will be introduced to the major interface features of RetinaEngrave
v3.0.
Figure 6.1
Technical Support is available from 8am to 5pm (PST) M - F at support@fslaser.com.
• 702-802-3103
47
47