Full Spectrum Laser MUSE 3D Operation Manual page 66

Section VII. Operations
Project Workflow
From Concept to Design
The RetinaEngrave v3.0 software works with your Muse 3D to create a simple and intuitive set of
operations that is easy to learn and use. With experience, you will find your Muse 3D achieving amazing
results following this procedure. Use this Project Workflow List for the "best practice" sequence for any
project and follow the step-by-step instructions from start to finish.
1. Create Design
Create your design in the
program of your choice.
Note: Files should be created
with laser cutting considered.
3. Import Design
Create your design in the
program of your choice.
Note: Files should be created
with laser cutting considered.
6. Adjust Object
Properties
Using the Properties Manager
Window, adjust your Vector or
Raster settings for your cut,
mark or engraving
2. Connect to Software
Link your Muse 3D to the software by
typing the IP address found on the Touch
Screen (Settings>Network>Copy IP) into
your browser (Google Chrome Suggested).
4. Place Material
Place your material into the laser
bed workspace.
7. Run Job
Double check your safety
precautions and accessories,
and press the "play" button to
start the job.
Technical Support is available 8am-5pm PST. Monday - Friday
support@fslaser.com
5. Align Laser
to Material
Using either the perimeter tool,
or camera function (see camera
features), align your design on the
appropriate area of your material.
• 702-802-3103
65