Camera Operations: Capture Workspace - Full Spectrum Laser MUSE 3D Operation Manual

Section VII. Operations
Camera: Capture Workspace
Camera: Capture Workspace
Use the onboard camera to capture your workspace to align your
Use the onboard camera to capture your workspace to align your design.
design.
1. Place material in center of laser bed.
1. Place material in center of laser bed.
2. Position the laser head above the material and use the focus billet to focus the cone above the material
surface. Ensure your material does not impede the movement of the laser head. *NOTE: If 3D Autofocuses.
2. Position the laser head above the material and use the focus billet to focus the cone above the
3. Initiate Camera Sequence - Press the Camera Icon on your RE2 software, or on the LCD touch screen (for
material surface. Ensure your material does not impede the movement of the laser head. *NOTE:
touch screen controls, see user manual) - Note that you 1) use the camera button, 2) position the head, and
3) press the camera button again (this initiates sequence with no indication on software). Follow the steps on
3D Autofocuses.
the screen. Click "New Height Measurement". The laser head will shift back and measure the height of your
material using the secondary red beam laser. You can repeat this step several times for more accurate results.
3. Initiate Camera Sequence - Press the Camera Icon on your RE2 software, or on the LCD touch
If results don't improve, it may be that your material is an uneven surface. Click Continue when focused.
screen (for touch screen controls, see user manual) - Note that you 1) use the camera button, 2)
4. After 9 photos are taken and stitched, your workspace should now represent your laser bed. Position your
position the head, and 3) press the camera button again (this initiates sequence with no indication o
design as needed (for help importing, see the Work-Flow Section), and adjust setting.
software). Follow the steps on the screen. Click "New Height Measurement". The laser head will sh
back and measure the height of your material using the secondary red beam laser. You can repeat
5. You are now ready to run your job. To double check a position on your workspace, CTRL-Click anywhere on
his step several times for more accurate results. If results don't improve, it may be that your the work space to position the laser head there
material is an uneven surface. Click Continue when focused.
4. After 9 photos are taken and stitched, your workspace should now represent your laser bed.
Position your design as needed (for help importing, see the Work-Flow Section), and adjust setting
5. You are now ready to run your job! To double check a position on your workspace, CTRL-Click
anywhere on the work space to position the laser head there.
Figure 7.18
Technical Support is available 8am-5pm PST. Monday - Friday
support@fslaser.com • 702-802-3103
82