Table of Contents
Advertisement
Each field is described in the following table.
Table 51 Network > NAT > Port Forwarding
LABEL
Default Server
Setup
Default Server
Port Forwarding
#
Active
Name
Start Port
End Port
Server IP Address This field displays the IP address of the server to which packet for the selected
Modify
Apply
Cancel
8.2.3 NAT Port Forwarding Edit Screen
Use this screen to activate, deactivate, and edit each port-forwarding rule in the ZyXEL
Device. To access this screen, click an Edit icon in Network > NAT > Port Forwarding.
Figure 65 Network > NAT > Port Forwarding > Edit
P-2302HWUDL-P1 Series User's Guide
DESCRIPTION
Enter the IP address of the server to which the ZyXEL Device should forward
packets for ports that are not specified in the Port Forwarding section below or in
the Management > Remote MGMT screens. Enter 0.0.0.0 if you want the ZyXEL
Device to discard these packets instead.
This field is a sequential value, and it is not associated with a specific rule. The
sequence is important, however. The ZyXEL Device checks each rule in order,
and it only follows the first one that applies.
Select this to enable this rule. Clear this to disable this rule.
This field displays the name of the rule. It does not have to be unique.
This field displays the beginning of the range of port numbers forwarded by this
rule.
This field displays the end of the range of port numbers forwarded by this rule. If it
is the same as the Start Port, only one port number is forwarded.
port(s) are forwarded.
This column provides icons to edit and delete rules.
To edit a rule, click the Edit icon next to the rule. The NAT Port Forwarding Edit
screen appears.
To delete a rule, click the Remove icon next to the rule. All the information in the
rule returns to the default settings.
Click this to save your changes and to apply them to the ZyXEL Device.
Click this to set every field in this screen to its last-saved value.
Chapter 8 NAT
121
Advertisement
Table of Contents
Troubleshooting
