The Port Forwarding Rule Edit Screen - ZyXEL Communications AMG1302-T10A User Manual

Chapter 9 Network Address Translation (NAT)

9.3.2 The Port Forwarding Rule Edit Screen

Use this screen to edit a port forwarding rule. Click the rule's edit icon in the Port Forwarding
screen to display the screen shown next.
Figure 70 Network > NAT > Port Forwarding: Edit
The following table describes the fields in this screen.
Table 45 Network > NAT > Port Forwarding: Edit
LABEL
Rule Setup
Active
Service Name
Start Port
End Port
Server IP
Address
Port Translation
Start / End Port
Back
Apply
Cancel
132
DESCRIPTION
Click this check box to enable the rule.
Enter a name to identify this port-forwarding rule.
Enter a port number in this field.
To forward only one port, enter the port number again in the End Port field.
To forward a series of ports, enter the start port number here and the end port number in
the End Port field.
Enter a port number in this field.
To forward only one port, enter the port number again in the Start Port field above and
then enter it again in this field.
To forward a series of ports, enter the last port number in a series that begins with the
port number in the Start Port field above.
Enter the inside IP address of the server here.
Enter the start port number here to which you want the device to translate the incoming
port. For a range of ports, you only need to enter the first number of the range to which
you want the incoming ports translated, the device automatically calculates the last port of
the translated port range.
Click this to return to the previous screen without saving.
Click this to save your changes.
Click this to restore your previously saved settings.
AMG1302-T10A User's Guide