The Port Forwarding Rule Edit Screen; The Address Mapping Screen - ZyXEL Communications P-660HN-F1A User Manual

9.3.2 The Port Forwarding Rule Edit Screen

Use this screen to edit a port forwarding rule. Click the rule's edit icon in the Port
Forwarding screen to display the screen shown next.
Figure 68 Network > NAT > Port Forwarding: Edit
The following table describes the fields in this screen.
Table 46 Network > NAT > Port Forwarding: Edit
LABEL
Active
Service Name Enter a name to identify this port-forwarding rule.
Start Port
End Port
Server IP
Address
Back
Apply
Cancel

9.4 The Address Mapping Screen

Note: The Address Mapping screen is available only when you select Full Feature
in the NAT > General screen.
P-660HN-F1A User's Guide
DESCRIPTION
Click this check box to enable the rule.
Enter a port number in this field.
To forward only one port, enter the port number again in the End Port
field.
To forward a series of ports, enter the start port number here and the end
port number in the End Port field.
Enter a port number in this field.
To forward only one port, enter the port number again in the Start Port
field above and then enter it again in this field.
To forward a series of ports, enter the last port number in a series that
begins with the port number in the Start Port field above.
Enter the inside IP address of the server here.
Click this to return to the previous screen without saving.
Click this to save your changes.
Click this to restore your previously saved settings.
Chapter 9 Network Address Translation (NAT)
179