Port Forwarding Edit Screen - ZyXEL Communications EMG6765-Q10A User Manual

Table 46 Network > NAT > Port Forwarding (continued)
LABEL
Apply
Cancel

13.3.1 Port Forwarding Edit Screen

This screen lets you edit a port forwarding rule. Click a rule's Edit icon in the Port Forwarding screen to
open the following screen.
Figure 62 Network > NAT > Port Forwarding Edit
The following table describes the labels in this screen.
Table 47 Network > NAT > Port Forwarding Edit
LABEL
Port Forwarding
Service Name
Protocol
Port
Server IP Address
Back
Apply
Cancel
Chapter 13 NAT
DESCRIPTION
Click Apply to save your changes back to the EMG6765-Q10A.
Click Cancel to begin configuring this screen afresh.
DESCRIPTION
Select Enable to turn on this rule and the requested service can be forwarded to the host with
a specified internal IP address.
Select Disable to disallow forwarding of these ports to an inside server without having to delete
the entry.
Select User define and type a name (of up to 31 printable characters) to identify this rule in the
first field next to Service Name. Otherwise, select a predefined service in the second field next
to Service Name.
Select the transport layer protocol supported by this virtual server. Choices are TCP, UDP, or
TCP_UDP.
If you have chosen a pre-defined service in the Service Name field, the protocol will be
configured automatically.
Type a port number(s) to define the service to be forwarded to the specified server.
To specify a range of ports, enter a hyphen (-) between the first port and the last port, such as
10-.
Type the IP address of the server on your LAN that receives packets from the port(s) specified in
the Port field.
Click Back to return to the previous screen.
Click Apply to save your changes back to the EMG6765-Q10A.
Click Cancel to begin configuring this screen afresh.
EMG6765-Q10A User's Guide
114