Lan Static Dhcp Screen; Figure 57 Network > Lan > Static Dhcp - ZyXEL Communications Network Device P-2302 User Manual

Table 45 Network > LAN > DHCP Setup
LABEL
Pool Size
DNS Server
First DNS Server
Second DNS
Server
Third DNS Server
Apply
Cancel

7.2.3 LAN Static DHCP Screen

This screen has no effect if the DHCP server is not enabled. You can enable it in
Network > LAN > DHCP Setup.
Use this screen to make the ZyXEL Device assign a specific IP address to a specific computer
on the LAN. To access this screen, click Network > LAN > Static DHCP.
Figure 57 Network > LAN > Static DHCP
P-2302HWUDL-P1 Series User's Guide
DESCRIPTION
Enter the number of IP addresses to allocate. This number must be at least one
and is limited by a subnet mask of 255.255.255.0 (regardless of the subnet the
ZyXEL Device is in). For example, if the IP Pool Start Address is 10.10.10.10,
the ZyXEL Device can allocate up to 10.10.10.254, or 245 IP addresses.
Specify the IP addresses of a maximum of three DNS servers that the network can
use. The ZyXEL Device provides these IP addresses to DHCP clients. You can
specify these IP addresses two ways.
From ISP - provide the DNS servers provided by the ISP on the WAN port.
User Defined - enter a static IP address.
DNS Relay - this setting will relay DNS information from the DNS server obtained
by the ZyXEL Device.
None - no DNS service will be provided by the ZyXEL Device.
Click this to save your changes and to apply them to the ZyXEL Device.
Click this to set every field in this screen to its last-saved value.
Chapter 7 LAN
111