Figure 225 Red Hat 9.0: Dns Settings In Resolv.conf; Figure 226 Red Hat 9.0: Restart Ethernet Card; Figure 227 Red Hat 9.0: Checking Tcp/Ip Properties - ZyXEL Communications Network Device P-2302 User Manual

Appendix D Setting up Your Computer's IP Address

Figure 225 Red Hat 9.0: DNS Settings in resolv.conf

nameserver 172.23.5.1
nameserver 172.23.5.2
3 After you edit and save the configuration files, you must restart the network card.
Enter
figure shows an example.

Figure 226 Red Hat 9.0: Restart Ethernet Card

[root@localhost init.d]# network restart
Shutting down interface eth0:
Shutting down loopback interface:
Setting network parameters:
Bringing up loopback interface:
Bringing up interface eth0:
Verifying Settings
Enter
ifconfig

Figure 227 Red Hat 9.0: Checking TCP/IP Properties

[root@localhost]# ifconfig
eth0
[root@localhost]#
320
in the
./network restart
in a terminal screen to check your TCP/IP properties.
Link encap:Ethernet HWaddr 00:50:BA:72:5B:44
inet addr:172.23.19.129 Bcast:172.23.19.255 Mask:255.255.255.0
UP BROADCAST RUNNING MULTICAST
RX packets:717 errors:0 dropped:0 overruns:0 frame:0
TX packets:13 errors:0 dropped:0 overruns:0 carrier:0
collisions:0 txqueuelen:100
RX bytes:730412 (713.2 Kb) TX bytes:1570 (1.5 Kb)
Interrupt:10 Base address:0x1000
directory. The following
/etc/rc.d/init.d
[OK]
[OK]
[OK]
[OK]
[OK]
MTU:1500 Metric:1
P-2302HWUDL-P1 Series User's Guide