Firmware Upload Screens; Figure 183 Firmware Upload In Process; Figure 184 Network Temporarily Disconnected; Table 127 Maintenance > Tools > Firmware - ZyXEL Communications Network Device P-2302 User Manual

Chapter 24 Tools
Each field is described in the following table.
Table 127 Maintenance > Tools > Firmware
LABEL
File Path
Browse...
Upload

24.2.2 Firmware Upload Screens

Do not turn off the device while firmware upload is in progress!
When the ZyXEL Device starts to upload firmware, the Firmware Upload in Process screen
appears.

Figure 183 Firmware Upload In Process

The process usually takes about two minutes. The device automatically restarts in this time.
This causes a temporary network disconnect. In some operating systems, you may see the
following icon on your desktop.

Figure 184 Network Temporarily Disconnected

After two minutes, log in again, and check your new firmware version in the Status screen.
You might have to open a new browser to log in.
274
DESCRIPTION
Enter the location of the .bin file you want to upload, or click Browse... to find it.
You must decompress compressed (.zip) files before you can upload them.
Click this to find the .bin file you want to upload.
Click this to begin uploading the selected file. This may take up to two minutes.
See Section 24.2.2 on page 274
Note: Do not turn off the device while firmware upload is in
progress!
for more information about this process.
P-2302HWUDL-P1 Series User's Guide