Isp Parameters; Figure 14 Connection Wizard > Isp Parameters (Ethernet); Table 6 Connection Wizard > System Information; Table 7 Connection Wizard > Isp Parameters (Ethernet) - ZyXEL Communications Network Device P-2302 User Manual

Chapter 3 Wizard Setup
The following table describes the labels in this screen.
Table 6 Connection Wizard > System Information
LABEL
System Name
Domain Name
< Back
Next >
Exit

3.2.3 ISP Parameters

This screen depends on the Connection Type you select.
3.2.3.1 Ethernet
You cannot use the
service. You must use the screens discussed in
Figure 14 Connection Wizard > ISP Parameters (Ethernet)
The following table describes the labels in this screen.
Table 7 Connection Wizard > ISP Parameters (Ethernet)
LABEL
Connection Type
< Back
50
DESCRIPTION
Enter your computer's "Computer Name". See
information. This is for identification purposes, but some ISPs also check this field.
This name can be up to 30 alphanumeric characters long. Spaces are not allowed,
but dashes "-" and underscores "_" are accepted.
Enter the domain name entry that is propagated to DHCP clients on the LAN. If
you leave this blank, the domain name obtained from the ISP is used. Use up to
38 alphanumeric characters. Spaces are not allowed, but dashes "-" and periods
"." are accepted.
Click this to go to the previous screen.
Click this to go to the next screen.
Click this to close this screen and return to the main screen.
Connection Wizard
DESCRIPTION
Select Ethernet.
Click this to go to the previous screen.
Section 22.1 on page 253
if you subscribe to a Roadrunner
Chapter 6 on page 95
P-2302HWUDL-P1 Series User's Guide
for more
instead.