Outgoing Calls; Incoming Calls; Figure 192 Outgoing Calls: Default; Figure 193 Outgoing Calls: Individual Configuration - ZyXEL Communications Network Device P-2302 User Manual

25.5.1 Outgoing Calls

The following figure represents the default behavior of your ZyXEL Device when two SIP
accounts are configured and you are using two phones. When you place a call from phone 1 or
phone 2, the ZyXEL Device will use SIP account 1.

Figure 192 Outgoing Calls: Default

In the next example, phone port 1 is configured to use SIP account 1 and phone port 2 is
configured to use SIP account 2. In this case, every time you place a call through phone port 1,
you are using your SIP account 1. Similarly, every time you place a call through phone port 2,
you are using your SIP account 2. To apply these configuration changes you need to configure
the Analog Phone screen. See

Figure 193 Outgoing Calls: Individual Configuration

25.5.2 Incoming Calls

The following example shows the default behavior of your ZyXEL Device for incoming calls
when two SIP accounts are configured and you are using two phones. When a call comes in
from your SIP account 1, the phones connected to both phone port 1 and phone port 2 ring.
Similarly, when a call comes in from your SIP account 2, the phones connected to both phone
port 1 and phone port 2 ring. In either case you are not sure which SIP account the call is
coming from.
P-2302HWUDL-P1 Series User's Guide
Section 10.2 on page 144.
Chapter 25 Troubleshooting
283