Dräger Caleo Instructions For Use Manual page 23

To remove the canopy:
1 Hold the canopy with both hands using the handles on
the side.
2 Lift the canopy horizontally off the pillar elements.
To replace the canopy:
2 Replace the canopy horizontally, so that the guide pins fit
into the holes in the pillar element.
NOTE
Take care of the sensor unit, risk of damage.
Removing the bed
Maximum load must not exceed 5 kg
Open the front flap and fold it down.
Pull the bed out:
3 Turn both knobs to the vertical position marked
4 Grasp the bed by the recessed handle or by the knobs and
pull it out towards the front as far as it will go.
WARNING
Patient can fall out! Danger to the patient.
When the bed is pulled out, the patient must be moni-
tored constantly to prevent the risk of a fall.
CAUTION
The bed can be damaged when leaning on it, maximum
load 5 kg.
Do not lean or rest any weight on the bed when it is
pulled out.
After carrying out the care operations, push the bed back
until it clicks into place. Turn the knobs to the horizontal
position marked , and close the front flap.
WARNING
If the bed is not fully pushed in, danger of interruption of
the hot air duct. The result may be excessive cooling or
overheating of the patient.
Slide the bed in fully.
1
2
,
3
Preparation
Doors, ports and bed
2
4
3
1
23