Connecting To A 100-Pin 0.5Mm Pitch Foot Pattern (Part 1) - Renesas M16C/6N User Manual

M306NKT-EPB User's Manual

2.9.5 Connecting to a 100-pin 0.5mm Pitch Foot Pattern (Part 1)

Here following is a procedure of connecting to a 100-pin 0.5mm pitch foot pattern on the user system using the M3T-F160-
100NSD (not included). For details on the M3T-F160-100NSD (not included), refer to its user's manual.
(1) Attach the NQPACK100SD-ND included with the M3T-F160-100NSD to the user system.
(2) Attach the YQPACK100SD included with the M3T-F160-100NSD to the NQPACK100SD-ND and secure it with the YQ-
GUIDE's.
(3) Attach the CN2 side of the M3T-F160-100NSD to the J4 side of the M306NKT-EPB.
(4) Attach the M3T-F160-100NSD to the YQPACK100SD.
These corners are not round.
*: These four items are available in one package .
Figure 2.13 Connecting to a 100-pin 0.5mm pitch foot pattern (Part 1)
Note on Connecting the User System:
Take care not to attach a converter board in a wrong direction. It may cause a fatal damage to the emulator and
user system.
Note on Connectors of the Converter board:
The connectors of the M3T-F160-100NSD are guaranteed for only 50 insertion/removal iterations.
REJ10J0519-0200 Rev.2.00 Oct. 16, 2006
M3T-FLX160-EPB
M306NKT-EPB
CN2 side
(3) M3T-F160-100NSD
(not included)
(4)
YQ-GUIDE(x4)
*
YQPACK100SD
(2) NQPACK100SD-ND
100-pin 0.5mm pitch
(PLQP100KB-A) foot pattern
(1)
No. 1 pin
CAUTION
IMPORTANT
On-board evaluation
HQPACK100SD
(not included)
FLASH MCU, etc.
User system
2. Setup
Page 37 of 104