D-Link DGS-3630 Series Reference Manual page 152

Web ui reference guide, layer 3 stackable managed switch
Hide thumbs Also See for DGS-3630 Series:
Table of Contents

Advertisement

DGS-3630 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
To view the following window, click Tools > Ping, as shown below:
The fields that can be configured in IPv4 Ping are described below:
Parameter
Target IPv4 Address
Ping Times
Timeout
Length
ToS
Stop Time
Click the Start button to initiate the Ping Test for each individual section.
The fields that can be configured in IPv6 Ping are described below:
Parameter
Target IPv6 Address
Ping Times
Timeout
Figure 11-36 Ping Window
Description
Select and enter an IP address to be pinged.
Enter the number of times desired to attempt to Ping the IPv4 address
configured in this window. Users may enter a number of times between 1 and
255. Tick the Infinite check box to keep sending ICMP Echo packets to the
specified IP address until the program is stopped.
Select a timeout period between 1 and 99 seconds for this Ping message to
reach its destination. If the packet fails to find the IP address in this specified
time, the Ping packet will be dropped.
Enter the length value here. This specifies the number of data bytes to send.
The default value is 56, which translates into 64 ICMP data bytes when
combined with the 8 bytes of ICMP header data. It does not include any VLAN
or IEEE 802.1Q tag length. The range is from 1 to 1420 bytes.
Enter the ToS value here. This is used to configure the QoS on ICMP
datagrams. The range is from 0 to 255.
Enter the stop time value here. This specifies to stop the ping after the amount
of times entered here. If this value is configured as 0, then the ping can only be
stopped by clicking the Stop button manually. The range is from 0 to 99.
Description
Enter an IPv6 address to be pinged.
Enter the number of times desired to attempt to Ping the IPv6 address
configured in this window. Users may enter a number of times between 1 and
255. Tick the Infinite check box to keep sending ICMPv6 Echo packets to the
specified IPv6 address until the program is stopped.
Select a timeout period between 1 and 99 seconds for this Ping message to
reach its destination. If the packet fails to find the IPv6 address in this specified
time, the Ping packet will be dropped.
145

Advertisement

Table of Contents
loading

This manual is also suitable for:

Dgs-3630-28pcDgs-3630-52pc

Table of Contents