Poe Statistics - D-Link DGS-3630 Series Reference Manual

DGS-3630 Series Layer 3 Stackable Managed Switch Web UI Reference Guide
To view the following window, click System > PoE > PD Alive, as shown below:
The fields that can be configured for PD Alive Configuration are described below:
Parameter
From Port - To Port
PD Alive State
PD IP Address
Poll Interval
Retry Count
Waiting Time
Action
Click the Apply button to accept the changes made.

PoE Statistics

This window is used to display and clear the PoE statistics on the Switch ports.
Figure 3-15 PD Alive Window
Description
Select the appropriate port range used for the configuration here.
Select to enable or disable the state of the PoE alive function on the specified
port(s) here.
Enter the IPv4 address of the target PD here.
Enter the poll interval value here. The range is from 10 to 300 seconds. This is
the interval at which ping requests will be sent to the target PD to check the
status.
Enter the retry count value here. The range is from 0 to 5. This is the amount of
times that the ping request will be resend if the target PD does not respond.
Enter the waiting time value here. The range is from 30 to 300 seconds. This is
the time the Switch will wait for the PD to recover from rebooting.
Select the action that will be taken here. Options to choose from are:
• Reset - Specifies to reset the PoE port state.
• Notify - Specifies to send logs and traps to notify the administrator.
• Both - Specifies to send logs and traps and then to reset the PoE port
state.
18