Poe(Dis-200G-12Ps And Dis-200G-12Psw Only); Poe System - D-Link Dis-200G Series Web Ui Reference Manual

PoE(DIS-200G-12PS and DIS-200G-12PSW Only)

This switch support Power over Ethernet (PoE) as defined by the IEEE 802.3af and 802.3at. All ports can
support PoE up to 30W. The Switch follows the standard PSE (Power Sourcing Equipment) pin-out
Alternative A, whereby power is sent out over pins 1, 2, 3 and 6. The Switches work with all D-Link
802.3af capable devices.
The Switch includes the following PoE features:
• Auto-discovery recognizes the connection of a PD (Powered Device) and automatically sends power
to it.
• The Auto-disable feature occurs under two conditions: firstly, if the total power consumption exceeds
the system power limit; and secondly, if the per port power consumption exceeds the per port power limit.
• Active circuit protection automatically disables the port if there is a short. Other ports will remain
active.
Based on 802.3af/at PDs receive power
according to the following classification:
Class
0
1
2
3
4

PoE System

This window is used to configure the PoE system, and display the detailed power information and PoE
chip parameters for PoE modules.
To view the following window, click System > PoE > PoE System, as shown below:
The fields that can be configured are described below:
Parameter
Usage Threshold
Trap State
Click the Apply button to accept the changes made.
DIS-200G Series Industrial Gigabit Ethernet Smart Managed Switch
Maximum power used by PD
12.95W
3.84W
6.49W
12.95W
25.5W
Description
Enter the usage threshold to generate a log and send the
corresponding standard notification. The range is from 1 to 99
percent.
Select this option to enable or disable the sending of PoE
notifications.
PSE provides power according to the following
classification:
Class
0
1
2
3
4
Figure 4-7 PoE System window
24
Maximum power used by PD
15.4W
4.0W
7.0W
15.4W
30W