Correlations - Mircom TX3 Series Configuration Manual

2.
3.
4.
5.
3.15

Correlations

Correlations establish specific relationships between inputs (events) and outputs
(actions) on different panels across the TX3 network. Use correlations to specify
the relationships between events, actions and schedules. For example, you can
configure the TX3 Nano so that when access is granted, an output on another
TX3 panel is activated.
The TX3 Nano allows a maximum of 128 correlations.
The TX3 Nano can send correlation messages to other devices on an existing
TX3 network.
The TX3 Nano sends correlations using IP. This means that the TX3 Nano sends
correlation messages to master nodes only. If any slave nodes are connected to
the master node, they can also receive correlation messages.
TX3 Nano Configuration Manual
Copyright 2019
In the Name section, type a name for the access point.
In the Timers section, provide information for each the following:
Auto Unlock Door. Select a schedule. During this schedule, the door is
unlocked. The default is Never.
Door Held Open Warning. Specify the amount of time in seconds for the
door to stay open until a warning is issued. The default is 30 seconds.
Door Held Open Alarm. Specify the amount of time in seconds for the
door to stay open until an alarm is issued. The default is 60 seconds.
In the Advanced section provide information for each the following:
Disable Forced Entry Alarm. If you select Yes, the forced entry alarm
does not activate even if the door is opened without permission. Instead,
access is granted. This is usually used on access points where there is no
request to exit (RTE) device. The default is No.
Report Door not Open. Select Yes to enable the panel to log and report
Door not open events to the Configurator when access is granted but the
door remains closed. The default is No.
Auto Relock. Select Yes to lock the door as soon as the door closes.
Selecting No locks the door, but only after the expiration of the Unlock
door for timer. The default is No.
Click Save Changes at the top of the window.
TX3 Nano Settings
33