Mircom TX3 Series Configuration Manual page 66

Table of Contents

Advertisement

10.
11.
12.
8.5.5
Enable DHCP
If you are using a static IP address and want to use DHCP instead, follow these
instructions to enable DHCP.
Enable DHCP
1.
2.
3.
Note:
8.5.6
Time Zone
By default, the TX3 Nano's time zone is Eastern Standard Time. Follow these
instructions to change the time zone.
Note:
Set the time zone
1.
2.
3.
4.
5.
6.
7.
TX3 Nano Configuration Manual
66
Copyright 2019
Select Save.
Select Enable Static IP.
Select, Yes, use new static IP.
The TX3 Nano restarts.
Connect the TX3 Nano to the network.
On the Panel Settings screen, select DHCP(Disabled).
Select YES.
The TX3 Nano restarts. After it restarts, DHCP is enabled.
The DHCP option shows DHCP(Enabled) or
DHCP(Disabled) to indicate whether DHCP is currently
enabled or disabled. By default, DHCP is enabled.
After you change the time zone, you must restart the TX3 Nano.
On the Panel Settings screen, select Set time zone and time.
Select Set time zone.
Select your continent.
Select your country.
Select your time zone.
Select YES.
Follow the instructions in section 8.5.8 on page 67 to restart the TX3
Nano.
Using the TX3 Nano

Hide quick links:

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the TX3 Series and is the answer not in the manual?

This manual is also suitable for:

Tx3 nano

Table of Contents

Save PDF