Figure 19. Discovered - Mircom TX3 Series Configuration Manual

The first TX3 Nano that you sign in to is called the master. The other TX3 Nanos
that you discover are called slaves. If you sign into another TX3 Nano on the
network, the master TX3 Nano will still be selected in the list of discovered TX3
Nanos. For simplicity, only sign into the master and configure the slaves by
selecting them in the TX3 Nano network.
For example, consider an installation with 3 TX3 Nanos. TX3 Nano A is the
master because it is the first TX3 Nano that you signed into. When you discover
TX3 Nanos B and C, they are added to the TX3 Nano network.
If you sign into the Configurator on TX3 Nano B, TX3 Nano A will still be
selected by default in the TX3 Nano network.
3.16.1 Discovery
This feature finds other TX3 Nanos and adds them to the TX3 Nano network. All
TX3 Nanos in this list are synchronized when you click the Sync button (section
3.16.2 on page 38). If you discover a TX3 Nano that you do not want to
synchronize, you can remove it.
Warning: If you remove a TX3 Nano and then discover it again, all of its
Discover other TX3 Nanos
1.
2.
3.
TX3 Nano Configuration Manual
Copyright 2019
settings will be reverted to the factory defaults.
Click Nano Setting in the left pane.
Click Discover at the top of the window.
Other TX3 Nanos on the network appear.

Figure 19. Discovered

Type a name for each TX3 Nano, and click the plus sign to add it.
TX3 Nano Settings
37