Figure 35. Panel Settings Screen - Mircom TX3 Series Configuration Manual

Note:
8.5.1 Navigating the Panel Settings
•
•
•
•
Note:
8.5.2 Panel Password
Change the panel password
1.
2.
TX3 Nano Configuration Manual
64
Copyright 2019
After you enter the panel password, the TX3 Nano shows the Panel
Settings screen (Figure 35).
If you sign into the TX3 Nano panel before you sign into the
Configurator for the first time, you will be forced to change the
panel password. Select 6 numbers for the password.

Figure 35. Panel Settings screen

Press the Scroll up and Scroll down buttons to move up and down the list.
Press the Call button to select.
Press the Home button to go back to the previous menu.
When entering an IP address, you must enter the dots. If the octet is a
single digit, enter 0 first.
For example, to enter the IP address 10.10.9.85, enter the following
characters: 1 0 . 1 0 . 0 9 . 8 5
The TX3 Nano will exit from the Panel Setting screen and show the
resident list after 20 seconds of inactivity. If you made changes but
did not save them, then the changes will be lost.
On the Panel Settings screen, select Set Password.
Select 6 numbers for the password.
Using the TX3 Nano