Tx3 Nano Configurator; Passwords; Sign Into The Configurator - Mircom TX3 Series Configuration Manual

This chapter provides an overview of the TX3 Nano Web-based Configurator.
This chapter explains
•
•
•
•
•
•
2.1

Passwords

The TX3 Nano has 2 passwords.
•
•
For security, the first time that you sign into the web-based Configurator, you
will be prompted to change both passwords.
2.2

Sign into the Configurator

You must configure the TX3 Nano with a Web browser.
Note:
Get the IP Address of the TX3 Nano
1.
2.
TX3 Nano Configuration Manual
Copyright 2019
2

TX3 Nano Configurator

Passwords
Sign into the Configurator
Global Settings
Backup and Restore
Factory Reset
Sign Out
The Configurator password is used to sign into the web-based
Configurator. The default is admin. When you change it, you must choose
a password of at least 6 digits.
The panel password is used to access settings on the TX3 Nano display
(see section 8.5 on page 63). The default is 111111. It can be a maximum
of 6 numbers.
The TX3 Nano does not work with Internet Explorer.
Connect the TX3 Nano's RJ45 connector to a LAN.
Press and hold the Home button for 10 seconds.
13