3.
Enter the following parameters:
When. This parameter defines the input event. Select one of the
following:
Access is denied. Resident denies access.
Access is granted. Resident grants access using their telephone
keypad.
Forced entry alarm. A door is forced open.
Door held open alarm. A door did not close and the door held open
alarm was issued.
Input activated. Select an input as defined in section 3.13 on page 29.
Call Started. A call to a resident is placed from the lobby.
Call finished. A call to a resident ends.
Call is connected. A call is established.
DTMF digit pressed. A specific DTMF digit is pressed on the
resident's phone. Select the digit in the DTMF trigger menu.
On panel. Select the panel that the action should occur on.
Action. Action specifies the type of action to occur for a specific input.
Select one of the following:
Turn ON output. The output becomes active.
Turn OFF output. The output becomes inactive.
Turn ON high security. Only credentials with the high security
privilege can open the door (card access panels only).
Turn OFF high security. All credentials can open the door (card
access panels only).
Panel label. If the selected panel is not a TX3 Nano, enter a name for the
panel.
Output. Select the output on the selected panel that should be turned on or
off if you selected Turn ON output or Turn OFF output above.
RS485. If the selected panel is not a TX3 Nano, enter its RS-485 address.
Panel IP Address. If the selected panel is not a TX3 Nano, enter its IP
address. If the selected panel is connected over RS-485 instead of IP, enter
the IP address of the Master Node (the IP-connected panel that it is
connected to).
TX3 Nano Configuration Manual
Copyright 2019
TX3 Nano Settings
35
Need help?
Do you have a question about the TX3 Series and is the answer not in the manual?