Networking; Figure 1. Tx3 Nano On An Ip Network - Mircom TX3 Series Configuration Manual

•
•
•
•
•
1.2

Networking

By default, the TX3 Nano is assigned an IP address from a DHCP server.
DHCP (Dynamic Host Configuration Protocol) is a way of assigning IP
addresses to devices on a network.
The TX3 Nano can be connected to an existing TX3 network, as shown in
Figure 1. The TX3 Nano supports IPv4 addresses. The TX3 Nano and other TX3
devices can communicate with each other through correlations.
TX3 Nano Configuration Manual
Copyright 2019
Touch buttons for scrolling the directory and making calls
Storage of up to 1000 names
Hands-free full duplex communication
Dials up to 20 digit telephone numbers
System can be configured over an IP network using a Web-based
configurator

Figure 1. TX3 Nano on an IP Network

Introduction
7