Recording On A Track - Yamaha AW2400 Owner's Manual

Direct recording and Mixed recording • Recording on a track
13
To monitor the signal levels sent from
Bus1/Bus2 to the record-ready tracks press
the [METER] key and then the [F3] key.
This calls the METER screen Master page, allowing
visual monitoring of the output levels from Bus1 and
Bus2.
Bus1 and Bus2 output level.
6
Now that the necessary preparations have been completed, let's record on a track.
1
Call the TRACK screen View page by either
pressing the Work Navigate section
[TRACK] key as many times as necessary,
or by pressing the [F1] key after pressing
the [TRACK] key.
This page can be used to confirm which tracks do and
do not contain recorded data. You can also make any
required metronome settings via this page (refer to
page 62 for metronome instructions).
56
AW2400 Owner's Manual

Recording on a track

Track view
14
Move the cursor to the POST FADER button
and press the [ENTER] key.
The post-fader signal levels will be displayed.
If the signal levels reach "OVER" on the meters press
the Layer section [MASTER] key so that it lights to
select the MASTER mixing layer, and use fader 1
(Bus1) and fader 2 (Bus2) to adjust the master levels
for Bus1 and Bus2 as required.
NOTE
• If you switch the RECORD display page after doing the patch
setup all your patch settings will be undone and lost (a confir-
mation popup window will appear). Remember to stay on the
same RECORD page until recording is finished.
2
Press the Transport section RTZ [
return to the beginning of the song.
3
Hold down the Transport section REC [●]
key and press the PLAY [
recording.
Recording will begin on the track set up as the record
destination. In the track view within the screen, the
vertical line that indicates the current location will
advance towards the right.
NOTE
• Recording will not begin if no track is in the record-ready
mode.
4
To stop recording, press the STOP [■] key.
The recorded audio data will appear in bar-graph form
in the track view.
The data entry/control section [UNDO/REDO] key
will light. This indicates that you can press the
[UNDO/REDO] key to execute the Undo function.
5
To hear the recording from the beginning,
press the RTZ [ ] key to return the
counter display to zero and press the PLAY
[ ] key.
] key to
] key to start