Yamaha AW2400 Owner's Manual page 254

Effects Parameters
■ REV->PAN
One input, two output reverb and autopan effects in parallel.
Parameter
REV TIME 0.3–99.0 s
INI. DLY 0.0–500.0 ms
HI. RATIO 0.1–1.0
DIFF. 0–10
DENSITY 0–100%
HPF THRU, 21.2 Hz–8.00 kHz
LPF 50.0 Hz–16.0 kHz, THRU
REV.BAL 0–100%
FREQ. 0.05–40.00 Hz
DEPTH 0–100%
*1
DIR.
WAVE Sine, Tri, Square
*1. L<–>R, L–>R, L<–R, Turn L, Turn R
■ DELAY+ER.
One input, two output delay and early reflections effects in parallel.
Parameter
DELAY L 0.0–1000.0 ms
DELAY R 0.0–1000.0 ms
FB. DLY 0.0–1000.0 ms
FB. GAIN -99 to +99%
HI. RATIO 0.1–1.0
HPF THRU, 21.2 Hz–8.00 kHz
LPF 50.0 Hz–16.0 kHz, THRU
DLY/ER 0–100%
S-Hall, L-Hall, Random,
TYPE
Revers, Plate, Spring
ROOMSIZE 0.1–20.0
LIVENESS 0–10
INI. DLY 0.0–500.0 ms
DIFF. 0–10
DENSITY 0–100%
ER NUM. 1–19
254
AW2400 Owner's Manual
Range
Reverb time
Initial delay before reverb begins
High-frequency reverb time ratio
Spread
Reverb density
High-pass filter cutoff frequency
Low-pass filter cutoff frequency
Reverb and panned reverb balance (0% = all panned reverb, 100% = all reverb)
Modulation speed
Modulation depth
Panning direction
Modulation waveform
Range
Left channel delay time
Right channel delay time
Feedback delay time
Feedback gain (plus values for normal-phase feedback, minus values for reverse-phase feedback)
High-frequency feedback ratio
High-pass filter cutoff frequency
Low-pass filter cutoff frequency
Delay and early reflections balance (0% = all delay, 100% = all early reflections)
Type of early reflection simulation
Reflection spacing
Early reflections decay characteristics (0 = dead, 10 = live)
Initial delay before reverb begins
Spread
Reverb density
Number of early reflections
Description
Description