Adjusting The Position Of A Locate Point Or Marker; Adjusting The Position Of A Locate Point - Yamaha AW2400 Owner's Manual

Adjusting the position of a locate point or marker

Here's how you can adjust the position of a previously-registered locate point or marker. These
operations are performed via the EDIT screen Mark Adj. page.
To call this page press the Work Navigate section [EDIT]
key as many times as necessary, or press the [F3] key after
pressing the [EDIT] key.
A
B
E
C
D
1 Locator Position field
Shows the various locate points (Quick Locator points not
included).
B Quick Locator/Marker field
Shows the Quick Locator or Marker points.
C LOCATOR button
D MARKER button
These buttons determine whether the Quick Locator or
Marker points appear in the Quick Locator/Marker field.
E DELETE button (Marker display only)
Deletes the currently selected marker.
Adjusting the position of a locate point or marker
Adjusting the position of
a locate point
1
Call the EDIT screen Mark Adj. page by
either pressing the Work Navigate section
[EDIT] key as many times as necessary, or
by pressing the [F3] key after pressing the
[EDIT] key.
2
The Locator Position field is used to edit
the various locate points (not including the
Quick Locator points).
The positions for each locator are displayed in the
Locator Position field.
A
1 Locate points
Shows the type of locate point and its abbreviation.
B Position
Shows the position of each locate point in time code or
the current counter display format.
C Measure/beat
Shows the position of each locate point as measures/
beats. This value is calculated based on the tempo and
time signature of the tempo map (→ p. 175).
The format in which the position is displayed will
depend on the locate point. The following table shows
the display format for each locate point.
Locate point Position
REL.ZERO Time code
START Time code
END Time code
IN Counter display format
OUT Counter display format
A Counter display format
B Counter display format
HINT
• If a locate point has not been registered "--" will appear in the
numerical field.
AW2400 Owner's Manual
B C
Measure/Beat
--
Measure/beat
Measure/beat
Measure/beat
Measure/beat
Measure/beat
Measure/beat
9
91