Initializing The Internal Hard Disk - Yamaha AW2400 Owner's Manual

About the CD-ROM included with the AW2400
Restoring the internal hard disk to the
factory-set condition
In order to restore the internal hard disk to the factory-set
condition, you will need to perform the following two pro-
cedures.
A Initialize the internal hard disk
B Load the demo song

■ Initializing the internal hard disk

Initialize the internal hard disk. (→ p. 212)
When you initialize the internal hard disk, the system set-
tings will return to their factory-set state.
NOTE
• Executing this operation will erase all data from the internal hard
disk, and the data cannot be recovered. We recommend you to
backup all data on the internal hard disk to a computer before exe-
cuting this operation.
■ Loading the demo song
You can load the demo song from the included CD-ROM
to restore the AW2400 to its factory-set condition.
1
Insert the included CD-ROM into the CD-RW
drive of the AW2400.
2
Call the SONG screen Restore page by either
pressing the Work Navigate section [SONG]
key as many times as necessary.
3
Make sure that the cursor is located at the
READ CD INFO button, and press the
[ENTER] key.
Loading from the CD-ROM will begin. When loading
is finished, the contents of the display will change as
follows.
4
Move the cursor to the list and press the
[ENTER] key.
The symbol at the left of the list will change to "●".
268
AW2400 Owner's Manual
5
Move the cursor to the RESTORE button and
press the [ENTER] key.
6
A popup window will ask you for confirma-
tion, so move the cursor to the OK button or
CANCEL button, and press the [ENTER] key.
While the Restore operation is being executed, the
state of progress will be shown in a popup window.
When this popup window closes, the operation has
been completed.
Installing a remote file
■ Supported DAW software
• Windows
(*1)
• Logic Platinum 5.5.1
• Cubase SX 3.0.1
• Nuendo 3.0.1
• Sonar 4.0.1 Producer Edition
• Macintosh
(*1)
• Logic Pro 7.0.1
• Cubase SX 3.0.1
• Nuendo 3.0.1
(*2)
• Protools TDM 6.7
*1 Use the setting file from the included CD-ROM to map the
AW2400's faders/[ON] keys/transport keys to the Logic key
commands. Track assignments must be made within Logic
as appropriate for your system.
*2 Select the CS-10 settings as the MIDI controller type. For
details on the CS-10 settings, ask Digidesign.