Yamaha AW2400 Owner's Manual page 81

10
Move the cursor to the POST FADER but-
ton, and press the [ENTER] key.
The post-fader signal levels will be displayed.
If the level meter reaches the "OVER" position, press
the Layer section [MASTER] key to make it light (the
MASTER mixing layer is selected), and lower fader 1
(Bus 1) and fader 2 (Bus 2).
NOTE
• All of the current patch settings will be erased if you switch the
RECORD screen page after making signal assignments. (A
popup window will ask you whether you really want to erase
the assignments.) Be careful not to switch the RECORD
screen page until you've finished recording.
11
To stop bounce-recording, press the STOP
[■] key.
12
To hear the bounce-recorded results from
the beginning, press the RTZ [
return the counter display to zero, and then
press the PLAY [ ] key.
When playing back the bounce-destination tracks, be
careful not to switch the RECORD screen to a page
other than the Bounce page or to defeat the bounce set-
tings.
If you do so, the connection from the bounce-source
track channels to the stereo bus will automatically be
restored. This will cause the bounce-source and
bounce-destination signals to be duplicated.
HINT
• If desired, you can use the [UNDO/REDO] key to cancel the
bounce-recording operation ( → p. 64), or switch the virtual
track of the bounce-destination and record another take ( →
p. 63).
13
When you've finished the bounce opera-
tion, press the Quick Navigation section
[RECORD] key once again, move the cursor
to the SAFE button in the screen, and press
the [ENTER] key.
A popup message will ask you for confirmation. Move
the cursor to the OK button and press the [ENTER]
key to defeat all bounce settings.
] key to
Bounce (ping-pong) recording procedure
AW2400 Owner's Manual
8
81