Simatic Step 7 In The Tia Portal; Introduction; Installing The Hardware Support Package (Hsp) - Siemens SITOP UPS1600 Manual

3.3

SIMATIC STEP 7 in the TIA Portal

3.3.1

Introduction

The uninterruptible power supply SITOP UPS1600 can be used with SIMATIC STEP 7 in the
TIA Portal from Version 12 with service pack 1 (SP1). From SW version V2.1, STEP 7 can
be used in the TIA Portal from Version 13.
In SIMATIC STEP 7 in the TIA Portal , the basic device SITOP UPS1600 and its battery
modules SITOP UPS1100 can be integrated in projects, parameterized and diagnosed.
Note
In order to use SITOP UPS1600 with SIMATIC STEP 7 in the TIA Portal, then you must
install the corresponding Hardware Support Package (HSP) or the corresponding generic
station description file (GSD). Using UPS1600 with HSP is only possible from TIA Version
V13. In TIA Version V12, only using GSD.
You can find additional information at Installing the Hardware Support Package (HSP)
(Page 43) or Installing the generic station description file (GSD) (Page 45).
Note
TIA and SITOP UPS Manager cannot simultaneously access SITOP UPS1600. The service
of the SITOP UPS Managers may not run while the system is accessed via TIA.
3.3.2

Installing the Hardware Support Package (HSP)

To use SITOP UPS1600, you must install the corresponding Hardware Support Package
(HSP) in the TIA Portal . This HSP is available at our SITOP-homepage
(http://www.siemens.com/sitop-ups1600) or directly under
(https://support.industry.siemens.com/cs/ww/en/view/75854606).
SITOP UPS1600 / UPS1100
Manual, 04.2016, A5E37775406-6-76
Engineering and remote access
3.3 SIMATIC STEP 7 in the TIA Portal
43