Mounting/removing
5.1
SITOP UPS1600
Installing the device in a housing or a control cabinet
The SITOP UPS1600s are built-in units. They must be installed in a housing or control
cabinet where only qualified personnel have access.
The device can be mounted in a control cabinet on standard TH35×7.5/15 mounting rails
(according to EN 60715).
Mounting
To mount the device, position it with the mounting rail guide at the upper edge of the
standard mounting rail and press down to lock it into place. If this is too difficult, press slider
⑩
at the same time, as described under "Removal".
Removal
To remove, carefully open the slider
Removal (example 6EP4136-3AB00-2AY0) (Page 139)) and disengage the device at the
bottom edge of the standard mounting rail. Then you can remove the device from the upper
edge of the standard mounting rail.
Image 5-1
SITOP UPS1600 / UPS1100
Manual, 04.2016, A5E37775406-6-76
WARNING
Removal (example 6EP4136-3AB00-2AY0)
⑩
using a screwdriver or by hand (see Image 5-1
5
139