Siemens SITOP UPS1600 Manual page 105

● Open the SITOP UPS Manager if battery replacement is recommended (from SITOP
UPS Manager V4.12.5 and higher).
● Open the SITOP UPS Manager once the battery has been replaced.
Behavior depending on the battery charge
Make the settings under "Software configuration > Battery charge".
The following options are available:
● Start the application when the battery charge is > 85 % of the maximum.
● Start the application when the battery charge is < 85 % of the maximum.
● Open SITOP UPS Manager when the battery charge is > 85 % of the maximum.
● Open SITOP UPS Manager when the battery charge is < 85 % of the maximum.
Note
From UPS Manager Version V4.71, a percentage value of the battery charge can be
programmed where an action should be initiated.
Behavior depending on the remaining buffer time
Make the settings under "Software configuration > Remaining buffer time". Specify the
minimum buffer time under "Hardware configuration > Base Unit" in entry "Buffer time".
The following options exist in the "Remaining buffer time" submenu:
● Start the application if the desired buffer time cannot be achieved.
● Start the application if the desired buffer time can be achieved again.
● Display the SITOP UPS Manager if the desired buffer time cannot be achieved.
● Display the SITOP UPS Manager if the desired buffer time can be achieved again.
Response when communication to the SITOP UPS1600 is interrupted
Make the settings under "Software configuration > Communication interface".
The following options are available:
● Start the application if there is a connection to the SITOP UPS1600.
● Start the application if the connection to the SITOP UPS1600 is interrupted.
● Open the SITOP UPS Manager if there is a connection to the SITOP UPS1600.
● Open the SITOP UPS Manager if the connection to the SITOP UPS1600 was interrupted.
SITOP UPS1600 / UPS1100
Manual, 04.2016, A5E37775406-6-76
Engineering and remote access
3.5 SITOP UPS Manager
105