Siemens SITOP UPS1600 Manual page 46

Engineering and remote access
3.3 SIMATIC STEP 7 in the TIA Portal
Note
Additional information on the Network view and Device view, as well as the Topology view is
available in the manual for your STEP 7 software.
Preconditions
● The hardware support package or the general station description file of the
SITOP UPS1600 has been installed.
● STEP 7 in the TIA Portal has been opened, and a project with an IO controller (SIMATIC
S7 control) has been created.
Inserting SITOP UPS1600 from the hardware catalog
1. Open the network view.
2. Open the "Hardware catalog" task card.
3. If you use the SITOP UPS1600 with the hardware support package:
In the "Catalog" palette navigate to SITOP UPS1600 under Power Supplies\SITOP
UPS\UPS1600.
4. If you use the SITOP UPS1600 with the general station description file:
In the "Catalog" palette, navigate to the SITOP UPS1600 under "Other
devices\PROFINET IO\I/O\Siemens AG\UPS1600".
5. Select the required SITOP UPS1600 using a mouse click.
In the "Information" area you can see information about the selected SITOP UPS1600,
and if necessary change the preselected version.
6. Drag the SITOP UPS1600 and drop it into the Network view.
Alternatively, you can add the module to the Network view by double-clicking on the entry
in the hardware catalog.
You have now inserted the SITOP UPS1600 into the project. The rectangle displayed in
the network view symbolizes the SITOP UPS1600.
46
SITOP UPS1600 / UPS1100
Manual, 04.2016, A5E37775406-6-76