Loading The Configuration (Commissioning) - Siemens SITOP UPS1600 Manual

"Web server" parameters
Parameter
Activate web server on this module
Permit access only with HTTPS
Log off automatically after 15 minutes
Update interval
Set here whether access to the UPS via web server is permitted.
● Activate web server on this module
Define whether this device can be accessed via the web server.
● Permit access only with HTTPS
Define whether access is only permissible via HTTPS.
● Download certificate
By pressing the "Download certificate" button, you can download the certificate for
encrypted connection via HTTPS.
● Log off automatically after 15 minutes
You define whether a user should be automatically logged off after closing the web
server.
● Update interval
You define in which intervals the actual values are sent to the web server.
3.3.8

Loading the configuration (commissioning)

In the delivered state, the SITOP UPS1600 has not yet been assigned an IP address and the
DHCP protocol is deactivated.
When the SITOP UPS1600 is first connected with a controller (SIMATIC S7- control system),
it must be assigned a device name and an IP address by the controller. A new configuration
can be loaded to the device using STEP 7 in the TIA Portal .
Identifying a SITOP UPS1600 in the network
From the STEP 7 in the TIA Portal , you can get the LED "SF" at the SITOP UPS1600 to
flash. This means that you can clearly identify a module in the network, e.g. if several
SITOP UPS1600 are installed in the network.
Preconditions
● The SITOP UPS1600 has been correctly connected and linked with the network.
● PG/PC with STEP 7 in the TIA Portal is connected with the network.
SITOP UPS1600 / UPS1100
Manual, 04.2016, A5E37775406-6-76
Value range
Yes / No
Yes / No
Yes / No
0 / 5 s / 10 s / 20 s / 30 s / 60 s
Engineering and remote access
3.3 SIMATIC STEP 7 in the TIA Portal
Default setting
Yes (up to V2.0)
No (from V2.1)
Yes
No
10 s
55