Toshiba TLCS-870/C Series Manual page 4

The Functional Differences on Products basis:
PM29B/FM29/CM29L.
Products name TMP86C829B
8K bytes
ROM
(MASK)
RAM 512 bytes
DBR
(Flash memory control/status registers <EEPCR, EEPSR> are non-available.)
I/O port
Large current output
(Nch) port
Interrupt sources
Timer/Counter
UART/SIO
Key-on wakeup
AD converter
LCD driver
Circuitry of TEST pin
Feedback resistor in
High- frequency circuit
(Note4)
Feedback resistor in
Low- frequency circuit
(Note4)
Emulation Chip
(Note2)
Package
Operating voltage
(Note 5)
Note 1: UART and SIO can not use function synchronously because each function pins are shared.
Note 2: An emulation chip (TMP86C929AXB) can't emulate the Flash memory functions, CPU wait and serial PROM mode.
Therefore, if the software which includes Flash memory function or CPU wait is executed in TMP86C929AXB, the opera-
tion might be different from TMP86FM29/CM29L.
Note 3: The operating temperature (Topr) of AD characteristics of all products (TMP86C829B/CH29B/CM29B/PM29A/PM29B/
FM29/CM29L) is -10
Characteristics" in data sheet of each product.
Note 4: The typical value of high and low frequency feedback resistor in TMP86FM29/CM29L are different from that of the other
products. For details, please refer to "Input/Output Circuitry" in data sheet of each product.
Note 5: The characteristic of power supply current differs in each product. For details, please refer to "Electirical Characteristics"
in data sheet of each product.
Note 6: The recommended operating condition of serial PROM mode in TMP86FM29 is different from MCU mode. Fore details,
please refer to "Electirical Characteristics" in data sheet of each product.
TMP86CH29B TMP86CM29B
16K bytes 32K bytes
(MASK) (MASK)
128 bytes
4 pins (Sink-open-drain output)
20 mA (Typ)
VDD
R
R
IN
= 1.2 M Ω(Typ)
R
f
= 6 M Ω(Typ)
R
f
P-QFP64-1414-0.80C
P-LQFP64-1010-0.50E
1.8V to 5.5V at 4.2MHz/32.768kHz
2.7V to 5.5V at 8.0MHz/32.768kHz
4.5V to 5.5V at 16MHz/32.768kHz
℃ to 85 ℃ when the supply voltage VDD is less than 2.0V. For details, please refer to "AD Conversion
TMP86C829B/CH29B/CM29B/PM29A/
TMP86PM29A
TMP86PM29B
32K bytes
(OTP)
1.5K bytes
39 pins
External: 5 Internal: 14
18bit Timer/Counter: 1ch
8bit Timer/Counter: 4ch
1ch (Note1)
4ch
10bit x 8ch (Note3)
32SEG x 4COM
No Protection
Diode (VDD side)
R
No Pull down
Resistor
TMP86C929AXB
TMP86PM29BUG
TMP86FM29 TMP86CM29L
32K bytes 32K bytes
(FLASH) (MASK)
128 bytes
(Flash memory control/status registers
<EEPCR, EEPSR> are available.)
4 pins (Sink-open-drain output)
6 mA (Typ)
VDD
R
R
IN
= 3 M Ω(Typ)
R
f
= 20 M Ω(Typ)
R
f
P-LQFP64-1010-
0.50D
1.8V to 3.6V at 8.0MHz/32.768kHz
2.7V to 3.6V at 16MHz/32.768kHz
(Note 6)