Tones Options - Electronics Line 3000 iConnect Installation Manual

8 Entry/Exit Timers and System Tones
8.7.2. Telephone Trouble Tones
Most trouble tones are not sounded between 10:00pm and 7:00am so as not to disturb the user late at night. Telephone
trouble, however, may be an attempt to sabotage the system by cutting the telephone wires. For this reason, you can
program telephone trouble tones to sound at all times.
To program the Telephone Trouble Tones option:
1. From the Programming menu, select Tones, Tel. Trb. Tones [937].
2. Select Immediate or Delayed.
8.7.3. Fire Trouble Tones
The Fire Trouble Tones option is a feature designed to repeat fire-related trouble tones until the problem has been
taken care of. If this feature is enabled, fire trouble tones will be repeated 3½ hours after the user has manually silenced
the tones if the trouble condition has not been restored.
To program the Fire Trouble Tones option:
1. From the Programming menu, select Tones, Fire Trb. Tones [938].
2. Select Enabled or Disabled.
Note: It is not necessary to program the Telephone Trouble Tones and Fire Trouble Tones options if the
Trouble Tones option is programmed as disabled.
8.8.

Tones Options

8.8.1. Tones Output
The Tones Output option enables you to determine whether the tones sounded when arming and disarming are
sounded by the Control System's built-in siren or its built-in speaker.
To program the Tones Output option:
1. From the Programming menu, select Tones, Tones Options, Tones Output [9391].
2. Select Siren or Speaker.
8.8.2. Speaker Volume
The Speaker Volume option determines the volume level of the tones sounded by the speaker.
To program the Speaker Volume option:
1. From the Programming menu, select Tones, Tones Options, Speaker Vol. [9392].
2. Select High or Low.
Note: It is not necessary to program the Speaker Volume option if "Siren" is selected for the Tones Output
option.
iConnect Installation Manual
55