Electronics Line 3000 iConnect Installation Manual page 14

Figure 1-12: Ethernet Communication module
1. Telephone Line terminal block: incoming line
from telephone company
2. Telephone Line terminal block: outgoing line
to telephone
3. Flat-cable interface connector to Main Board
4. RJ45 Ethernet Port
5. USB connector to PC firmware management
Note: two optional metal covers can be
installed into the slots shown in this
figure.
Cautions: Do not use VoIP phone lines for communication to the central monitoring station. In certain cases
the system may not transmit alarm signals successfully over the VoIP network.
To reduce the risk of fire, use only No. 26AWG or larger telecommunication wire.
1.4.6. PSTN Communication Module
The PSTN module provides the system with a standard dialer for communication via the Public Switched Telephone
Network (PSTN).
Figure 1-14: PSTN Communication Module
1. Flat cable interface connector to Main Board
2. Metal cover
3. USB connector to PC firmware management
4. Telephone Line terminal block: incoming
line from telephone company
5. Telephone Line terminal block: outgoing
line to telephone
6. Metal Cover
7. Status LED
8
Figure 1-13: Ethernet only Communication Module
1. Flat-cable interface connector to Main Board
2. RJ45 Ethernet Port
3. USB connector to PC firmware management
Note: one optional metal cover can be
installed into the slot shown in this
figure.
1 Introduction
iConnect Installation Manual