Troubleshooting; Troubleshooting Guide - Permobil Explorer Mini Service Manual

Explorer Mini

6 Troubleshooting

6.1

Troubleshooting guide

This troubleshooting guide describes the most common events that can
occur when you use the Explorer Mini. It also describes possible causes
and remedies. This troubleshooting guide is not exhaustive.
NOTICE
Unapproved replacement of parts
If any part is replaced without approval from Permobil, the wheelchair
warranty will become void. Permobil accepts no liability for any loss that
occurs as a result of a control system component being opened, adjusted or
modified without permission.
Event
The Explorer Mini does not start.
The Explorer Mini cannot be driven.
The Explorer Mini will automatically be
turned off after a period (90 minutes) of
inactivity.
The Explorer Mini stops during driving.
The Explorer Mini cannot be charged.
Possible cause
The batteries are discharged.
The battery saving function has started.
Explorer Mini is turned off. The main
circuit breaker is turned off or tripped.
The main circuit breaker is turned on, but
the start button has not been pressed.
The battery charger is connected.
The Explorer Mini is locked.
The battery saving function has been
started.
The main circuit breaker is tripped.
The batteries are discharged.
The main circuit breaker is turned off.
The main circuit breaker is turned on, but
the start button is not pressed.
Either an incorrect battery charger is used
or the battery charger is damaged.
Troubleshooting - Troubleshooting guide
Remedy
Charge the batteries.
For instructions, see
4.10.1 Charging the batteries .
Press and hold the start button for at least
one second.
Reset the main circuit breaker and press
and hold the start button for at least one
second.
For instructions on tripped main circuit
breaker, see 4.11.1 Electrical fault .
Press and hold the start button for at least
one second.
Stop the charging procedure and
disconnect the charger cable from the
charger socket on the Explorer Mini.
Unlock the wheelchair.
For instructions, see .
Press and hold the start button for at least
one second.
For instructions on tripped main circuit
breaker, see 4.11.1 Electrical fault .
Charge the batteries.
For instructions, see
4.10.1 Charging the batteries .
Turn on the main circuit breaker and press
and hold the start button for at least one
second.
Press and hold the start button for at least
one second.
Make sure that you use the battery charger
that was supplied with the Explorer Mini.
If it still is not possible to charge, you may
need to replace the battery charger.
73