Table of Contents
Advertisement
Dismantling the Equipment Frame ProFlex
!
WARNING!
Exercise caution.
Risk of crush injuries.
Starting position for removing the cutting
unit frame:
Cutting unit removed.
1.
Twist the catch out so that the forward
fastener can be lifted from the cutting
unit.
2.
Move the unit frame backwards so that
the tongue of the cutting unit releases its
grip on the bar of the unit frame and lift
the frame off.
Assemble the parts in the reverse order.
Changing the Belt on the Cutting
Unit Combi 94, 103, 112, 122
On cutting units with 'collision-proof' blades,
the blades are driven by a V-belt. Do as
follows to replace the V-belt:
1.
Loosen the equipment frame (1) on
ProFlex, bolt on the parallel strut (2) and
the two screws on the cover (3). Lift off
the cutting unit cover.
2.
Loosen the spring (4) that tensions the
V-belt and pull the belt off.
Attach a new belt in the reverse order.
Position the belt as illustrated. The belt
position diagram is also on a decal on
the inside of the cover.
100
English-
REPAIR INSTRUCTIONS
Unit frame lock
Tongue and handle
3
Removing the cover
Belt tensioner spring
8009-184
8009-185
3
1
2
6016-113
8009-376
Advertisement
Table of Contents
