Table of Contents
Advertisement
DELIVERY AND DEALER SERVICE
Check that the cutting unit works and that no
unusual sounds are heard.
Using the lever, the cutting height can be
adjusted in 7 different positions.
Check that the hydraulic cutting unit lift is
functioning on the ProFlex 21.
Engine Speed Regulator
Check that the engine's max. speed is
regulated to:
Rider Pro 18
2825-2975 rpm
Rider ProFlex 21
2825-2975 rpm
Inspecting the Muffler
Check that the muffler is fitted securely.
Temperature variations and vibrations can
mean that the tightening torque for the
screws drops. The screws should be checked
to ensure the correct tightening torque. The
check should be made after test running as
any paint will then be burnt off. The tightening
torque should be approximately 10 Nm.
!
WARNING!
The muffler gets very hot in use
and remains so for a short time
afterwards. Contact can result in
burns. Remember the risk of fire.
22
English-
Cutting height setting
Hydraulic cutting unit lift
Mounting bolts muffler
8009-327
8009-326
8009-683
Advertisement
Table of Contents
