Removing the Pendulum Shaft
1.
Jack up the rider in front of the rear
frame.
2.
Remove the pump unit, see "Pump Unit"
on page 52.
3.
Clean, see "Working Methods" on
page 114. Release the rear hydraulic
hose from the rear axle.
4.
Remove the circlip and washer from the
pendulum shaft and pull loose the rear
frame.
5.
Remove the circlip and washer from the
pendulum shaft's inner mount (1) and
pull the shaft out to the rear. Use a
sledgehammer or puller if needed.
If the dust cover (2) is damaged, it
should be replaced with a new one.
Replacing Bushings
Once the pendulum shaft is removed, replace
the bushings in the rear frame.
Remove these with a punch, see"Special
Tools" on page 5.
New bushings are fitted with the punch
see"Special Tools" on page 5. Make sure that
the bushing grooves are lined up horizontally.
It is important that the outer bushing's outer
edge is on the same level as the outer edge
of the hole. The bushings should first be
lubricated with a lithium-based lubricant.
50
English-
REPAIR INSTRUCTIONS
Jacking up
Hydraulic hose
Pendulum shaft
Replacing bushings
6012-029
8009-706
6012-031
8009-044