Table of Contents
Advertisement
3.
Check the measurement of the adjuster
screws' position. Note the values and
use these as initial values when
assembling.
4.
Unscrew the adjuster screws completely
so that the springs release.
5.
Remove the split pin and release the link
for the height adjustment from the
triangular link.
6.
Lower the equipment frame with the
mechanical lever. Insert a small
screwdriver or the like through the chain,
so that it can not slide into the frame
tunnel, and release the chain from the
equipment frame.
7.
Remove the equipment frame's rear
guide screws. In order to completely
lower the equipment frame on the left-
hand side, it must first be pulled back.
REPAIR INSTRUCTIONS
Control measurement
Link height setting
Chain bracket
Rear guide screw
8009-635
8009-633
8009-701
8009-634
85
English-
Advertisement
Table of Contents
